PMON Targets
PMON supports any of LSI Logic's Evaluation boards as a Target. Each
PMON target needs to be equipped with a set of suitably configured PMON
Proms. This package currently builds for the following boards.
BDMR400x (4001/2/3) Evaluation Board
- Insert the four flash memories containing PMON in U8,
U19, U29, and U40. Note that this board can be configured for
big or little endian byte ordering (J1).
- Connect a serial cable from U28 to the
Host.
BDMR4101 (4101) Evaluation Board
- Insert the four flash memories containing PMON in U5,
U6, U7, and U8. Note that this board can be configured for
big or little endian byte ordering (J1).
- Connect a serial cable from J28 to the
Host.
BDMR4102 (4102) Evaluation Board
- Insert the EPROM containing PMON in U25.
- Connect a serial cable from J10 to the
Host.
Nitro (4010) Evaluation Board
- Insert the flash memory containing PMON in U18.
- Connect a serial cable from J18 to the
Host.
Nitro II (4011) Evaluation Board
- Insert the EPROM containing PMON in U4.
- Connect a serial cable from J19 to the
Host.
SDP1000 (64008) RevA Evaluation Board
- Insert the two flash memories containing PMON in U42 and U44.
- Connect a serial cable from CON9 to the
Host.
SDP1000 (64108) RevB Evaluation Board
- Insert the two flash memories containing PMON in U50 and U49.
- Connect a serial cable from port1 to the
Host.
ATMizer-2 RT Platform
- Build two PMON configuartions: one for the ATMizer-2 Host, and one
for the ATMizer-2 Sar. Insert the two flash memories in the respective
sockets.
- Connect two serial cables to the
Host: one from the Host-board's tty0, and
one from the Sar-board's tty0.
Navigation:
Document Home |
Document Contents |
Document Index