Building the PMON package

The steps required to build the PMON package are somewhat host dependent, so please refer to the appropriate section below:

MSDOS Hosts

If you have a copy of Microsoft's Visual C++ package on your host, perform the following steps:
1. Set your environment.
2. If you don't have a set of PMON ROMS for your Target board, type
```
	C> nmake pmon-only
```
  this will build all of the directories needed for PMON. The build is controlled by the top-level makefile. Or if you already have a set of PMON ROMS for your Target board, type
```
	C> nmake 
```
If you don't have a copy of Microsoft's Visual C++ package on your host, perform these alternative steps.
1. If you don't have a set of PMON ROMS for you Target board, visit the PMON Web site and collect a prebuilt ROM-image file. Perform the file extraction in the top-level directory of this package.
2. Visit the PMON Web site and pick up a copy of the appropriate prebuilt library file. Perform the file extraction in the top-level directory of this package.

Finally, if you need to make a set of PMON ROMS for your Target board, follow this procedure.

Navigation: Document Home | Document Contents | Document Index