Windows NT 4.0

Introduction:
-------------
This document describes the procedure to install  Windows NT v4.0 
driver for 32Bit 10/100/1000Mbps Gigabit Ethernet Adapter.

Location of Driver:    A:\WINNT\GNC01T.SYS

Installing driver procedure on Microsoft Windows NT :
-----------------------------------------------------
When you are in Windows NT :
 1. Select the 'Network' icon in the Control Panel Group.
 
 2. Select the 'Adapter' and click the 'Add' button in the 'Network'
    Dialog Box.
 
 3. Click the 'Have Disk' button in the 'Select Network adapters' Dialog
    Box.
 
 4. Insert the 32Bit 10/100/1000Mbps Gigabit Ethernet Adapter Driver 
    Diskette in drive A, enter drive and pathname A:\ which is the path 
    where the setup file Oemsetup.inf is located,and then choose the OK 
    button.
 
 5. The screen will appear "Duplex Mode" dialog box which is provide
    by GNC01T.SYS driver. 
 
 6. NT will then perform the binding process.If any additional network
    software options were installed,you may be prompted for specific
    information for these packages.
 
 7. Restarting your system you will acquire network service.
